[Manifold-l] Line editing

[Springfield HARRISON]

Thank you.  Dimitri pointed me to Decompose on the Forum . . .


Hello Dimitri:

Works perfectly!  Decompose - who knew?!

Thank You . . . . Spring Harrison

Cheers . . . . Spring

----- Original Message -----
From: jburn_gis at cogeco.ca
Date: Friday, June 1, 2007 2:59 pm
Subject: re: [Manifold-l] Line editing

> I think I understand - you used the "split" command on the edit 
> bar, correct?  This will split your line, but into two
> *branches*, not two lines.  All you have to do now is use the 
> "decompose" transform (make sure your transfer rules are
> set to copy to avoid data loss) and you should get two lines out 
> of your two branches.  Might want to make sure you do
> it only on your selected line(s).
> 
> Cheers.
> 
> >
> > Hello:
> >
> > Trying to split a line where it intersects another.  I've 
> dutifully used the editing tools as described but to no
> > effect.
> >
> > I earlier ran Normalize Topology, Joined Lines and have snapped 
> line ends to the nodes of adjoining lines.  I even
> > extended one line over the other and tried Split but I still 
> just have one line.
> >
> > Is there a trick here that I'm missing?
> >
> > Thank You!
> >
> > Cheers . . . . Springfield Harrison
> > _______________________________________________
> > Manifold-l mailing list
> > Manifold-l at lists.directionsmedia.net
> > http://www.directionsmedia.net/mailman/listinfo/manifold-l
> 
> --------------
> James Burn AScT
>