[Manifold-l] v 7.1.2.408 and "Unknown Error"

[Simon Greener (SpatialDB Advisor)]

I too am getting lots of "Unknown Error" popups but I am trying to test
the new Topological Overlay improvements to see if I can reliably and  
quickly
do an ESRI Identity on two reasonably large polygon drawings.

I kept getting this a lot so I cut my map file back to two drawings: one a  
set
of convex hulls generated by Manifold from a set of points and the other a
polygon drawing generated by a delaunay triangulation from the same points.
I can normalise topology the convex hulls but keep getting the "Unknown  
error"
popup when trying to normalise topology for the delaunay triangulated  
polygon drawing.

If I can't get this to normalise I will send a report to sales but until I  
do I thought
I would post to the list to comment that I was getting this dialog when  
not processing images...

regards
S
-- 
--------------------------------------------------
Simon Greener
SpatialDB Advice, Solutions Architect,
Oracle Spatial, MYSQL, PostGIS and Manifold enthusiast
Allens Rivulet, Tasmania, Australia.
Voice: +61 3 62396397
Longitude: 147.2048
Latitude: -43.0141